2003-08, Oil gallery plugs

Here's something unusual that cropped up a little while ago that I've never commented on before - main oil gallery plugs/bungs.

I'd been conversing via e-mail with a guy that was experiencing weird oil flow/supply problems with his performance street engine. Initially he'd been blaming it on the supposedly superior oil pump he'd bought. He sent it to me; I inspected it and found it to be in perfect health with no signs of causing the issues in hand. Firstly there was a claimed total oil drain down from the pump causing lack of initial supply on start-up for a few seconds, and then repeated crank bearing failures when used in anger (i.e. at high rpm for protracted periods). Unless there is something drastically wrong with the oil pump and fitment - cracked pump body, non-flat mounting surface, mounting bolts too long, split gasket, etc. - it will not drain down simply because the inlet and outlet ports are above the centerline, near the top of the pump as it is mounted to the block.

Lubrication - Temperature critical

The correct running temperature of the oil is perhaps even more important than the water/coolant temperatures - so let us consider how to control them.

Mainly because it seems to be the most misunderstood of the whole process, and oil cooler fitment almost a reflex when over-heating occurs where a tuned engine of any type is concerned. And in many cases on standard production road cars for that matter.

Almost since the appearance of the immortal Cooper S, fitting an oil cooler has been the essential thing to do to any tuned Mini without any comprehension why. The original fitment was necessary because oil and bearing technology wasn't too advanced. Asking an oil of yester-year to cope with lubricating an engine at racing speeds, and a gearbox pushed their performance to the edge of their all too narrow capability, so extreme control over their working environment was essential for reliability. Hence oil cooler fitment.

HILO - ADJUSTABLE MINI SUSPENSIONFITTING INSTRUCTIONS

Suitable for all Minis with “dry” rubber cone suspension, including vans, Travellers and Riley/ Wolseley saloons. General Information

These specialized and RAC FIA homologated suspension components are designed to allow the ride height of all Minis with “dry” suspension to be easily adjusted. In addition, the diameter of the rubber cone support lip is larger than the standard cone to increase effective spring rate. This makes them suitable for fitment in all the following cases:-

ROAD CARS - For load carrying and towing to optimise handling and adjustment.

RALLY CARS - Increase height for rough forestry stages then lower for smooth tarmac.

RACE CARS - Stiffen and lower the suspension as far as possible but can still be raised for bumpy circuits.

C-AEG410, C-AEG411, C-AEG412, C-AEG413, C-AEG414, and GLP110MSSUREFLOW OIL PUMPS...

PLEASE READ THESE INSTRUCTIONS FIRST

The pumps are thoroughly cleaned when assembled, so only priming the pump is necessary prior to fitment. A precautionary testing of the pump prior to priming is recommended - merely turn the rotor using thumb and forefinger engaged on the pump drive. It should turn freely. If it does not, it will be necessary to strip the pump down to make sure no debris is causing the problem. Make careful note which way up the annulus fits and ensure it goes back the same way. Prime the pump with preferably engine building lubricant (less likely to drain away before start up is effected).

If not properly primed, oil pressure may not be obtained; crankshaft and bearing damage may result.

Make sure the retaining bolts do not bottom out in the relevant tapped holes in the block before securely clamping the pump to the block. Any air leaks caused by using bolts that are too long will cause oil pressure deficiencies, drai...

Choice of radiators

Choice of radiators

Radiators Read about heat conductivity, core, fin design, tube sizes and design changes